• img1
  • img2
  • img3

+86-537-3281595

info@qfmh.com

Product Categories

Contact Us

Shandong Jining Qingfeng Machinery Hardware Co.,Ltd

Add: NO.47 Jinyu Road, Jining, Shandong

Contact: Qin Wang

Tel: +86-537-3281595

Fax: +86-537-3281597

Mobile: +8613705473076

E-mail:info@qfmh.com

Web: www.qfmh-tools.com

Home > Knowledge > Content
What problems should we pay attention to when using hydraulic tool holder

1. When the hydraulic tool handle is pressurized, please tighten the bolt completely with the T-wrench.

When the bolt is completely tightened, it will stop turning. The hydraulic holding force of the hydraulic tool handle of our company is the best when the bolt is fully tightened.


2. When the hydraulic tool holder is fitted with the cutting tool, one end of the tool should be close to the lower end of the internal part of the hydraulic tool holder.

If the end of the cutting tool is too short to be close to the bottom of the hydraulic tool handle, the position of the cutting tool end should not be more than 8 mm away from the bottom of the tool handle. (Otherwise, the inside diameter of the tool handle will shrink and be damaged, and the tool handle will leak oil.)

3. Before installing the knife on the hydraulic knife handle, the moisture and oil in the knife handle should be removed.

Because the tool holder is not cleaned and directly loaded, the cutting tool will fall off because of the liquid foreign body inside the tool holder. (Clean the inside of the tool handle before loading the milling cutter)

4. Do not open or pull the hydraulic hole on the hydraulic tool handle at will.

When the hydraulic hole is opened or pulled at will, the hydraulic oil will be lost, and the hydraulic tool holder will not be able to continue to use and maintain.

5. Do not install rough cutting tools.

6. When the screw part of the tool handle is damaged or the hydraulic pressure cannot be processed properly and needs A/S maintenance, please do not disassemble and assemble the tool handle by yourself. Please contact the supplier.


Contact Us
Shandong Jining Qingfeng Machinery Hardware Co.,Ltd

Address: NO.47 Jinyu Road, Jining, Shandong

Tel: +86-537-3281595

Fax: +86-537-3281597

E-mail: info@qfmh.com

Copyright © Shandong Jining Qingfeng Machinery Hardware Co.,Ltd All Rights Reserved.